Only those who do not have enough experience in sourcing their thread plug gauges and thread taps will be settling for inferior quality products. If you know what you are doing and if you have been in this field for quite some time then you would always give priority for quality over the low costs. Does this mean you should spend an exorbitant amount of money on the thread gauges and thread taps?
No, it is not necessary to spend an exorbitant amount of money on the thread gauges and thread taps. All that you need to do is to take into consideration your long-term savings instead of your short-term savings. How does this work and what exactly needs to be done? When you are ordering you’re your ACME thread tap from a manufacturer that delivers inferior quality thread taps but provides you with an impressive quote thinking that you are saving money on the thread taps, then you are not. The inferior quality thread tap will break in no time and you would be replacing it too frequently. If you calculate the amount of money you have spend on the thread taps on the long run you would notice that you have almost doubled the expenses by sourcing low priced thread taps. In other words, even though initially it appears to be saving you money on the long run you are not actually saving any money but spending more. You are not getting the best value for your money.
In case you had taken the time to scout the web checking the credentials of the suppliers, their reputation and even gone to the extent of ordering sample thread gauges and thread taps before placing the order then you would have spotted the best suppliers. Even if you had to pay a little extra money initially because these thread gauges and thread taps last longer than the inferior quality thread taps or thread gauges you would be replacing them less frequently. Instead of learning this lesson in an expensive way by going through the entire sourcing cycle and changing your approach, you could change your approach right away and look for companies that deliver nothing but the best.
You should also take into consideration the losses caused by the downtime when a thread tap breaks. You would lose anywhere from several minutes to several hours depending on the nature of the breakage. This will result in lot of losses and when you take these losses also into account you would know how foolish it is to go with inferior quality thread taps of thread gauges just to save a fraction of the cost. There are many dependable thread gauges suppliers in China that are committed to delivering you with outstanding quality tools and you should take advantage of such suppliers so that you could also save some money as you are sourcing the tools from China.